LOAD CONTROL SWITCHES

The i-LiNE load control switches have been designed to provide local control over lights and motors. The two basic load switches are the i-ON relay ON/OFF switch and the i-ON-D dimmer switch. In addition, the i-ON-Dlv low-voltage dimmer switch is now shipping.

The i-LiNE load control switches have been designed to comply with Underwriters Laboratories (UL) and National Electrical Code (NEC)  specifications. See below for details of the applicable NEC code specifications.

Load Control Switches

LOAD CONTROL SWITCHES OVERVIEW

230VAC, 50Hz Switches Now Available

i-ON-R - High Power Relay Load Control Switch, 1500 Watts, 120VAC, 60Hz and 230VAC 50Hz. Elegant flush mounted switch. Available in White, Almond, Ivory, and Custom Colors*.

COMING SOON

Additional Details

Additional Details

COMING SOON

Additional Details

COMING SOON

Additional Details

IMPORTANT NOTICE

 Attention Installers and Inspectors

This device has been designed to comply with the National Electrical Code concerning the use of low voltage cabling in the same enclosure as 120 VAC cable. The i-LiNE device network connecting cable MUST have a jacket insulation rating of 120 VAC or greater and be UL listed. Please refer to the NEC code Chapter 3 Section 300.3(c)(1) for additional information.

NEC 300.3(c)(1)

(C) Conductors of Different Systems.

(1) 600 Volts, Nominal or Less. Conductors of circuits rated 600 volts, nominal, or less, ac circuits, and dc circuits shall be permitted to occupy the same equipment wiring enclosure, cable, or raceway. All conductors shall have an insulation rating equal to at least the maximum circuit voltage applied to any conductor within the enclosure, cable, or raceway.

NEC 725.55(D)

(D) Associated Systems Within Enclosures. Class 2 and Class 3 circuit conductors in compartments, enclosures, device boxes, outlet boxes, or similar fittings shall be permitted to be installed with electric light, power, Class 1, non-power-limited fire alarm, and medium power network-powered broadband communications circuits where they are introduced solely to connect the equipment connected to Class 2 and Class 3 circuits, and where (1) or (2) applies:

(1) The electric light, power, Class 1, non-power-limited fire alarm, and medium power network-powered broadband communications circuit conductors are routed to maintain a minimum of 6 mm (0.25 in.) separation from the conductors and cables of Class 2 and Class 3 circuits.

(2) The circuit conductors operate at 150 volts or less to ground and also comply with one of the following: a. The Class 2 and Class 3 circuits are installed using Type CL3, CL3R, or CL3P or permitted substitute cables, provided these Class 3 cable conductors extending beyond the jacket are separated by a minimum of 6 mm (0.25 in.) or by a nonconductive sleeve or nonconductive barrier from all other conductors. b. The Class 2 and Class 3 circuit conductors are installed as a Class 1 circuit in accordance with 725.21.